รายละเอียดสินค้า
อะไหล่ชุดผลิตโอนโซน Ozone 18g Inner Enamel Tube Inner Ozone Generator (สินค้า Pre-Order)
>> แจ้งความต้องการสินค้า <<
.
Dimension:
- 18g: 233mm 272mm
- 30g: 292mm 332mm
- 40g: 411mm 450mm
- 60g: 551mm 590mm
- 80g: 656mm 696mm
There are 3 reasons that can cause the damage of the tube, below is the problem and sloving, please read it carefully to prevent any such problems.
- the feeding sources is not clean or dry enough. We require pure oxygen, or dry and clean ambient air, with dew temperature -40degree.
- The cooling water is not sufficient. (Vertically install the tube, make sure the cooling water go from the bottom to the top, so there is full water in the tube all the time. the cooling water temeperature should be within 8 degree difference compared the working environment temperature, to prevent condensate. Also, please check if cooling water is pure, if too much impurity, it can block the water inlet, so water can go in to cool the electrodes)
- There is water back flow into the enamel tube. (When mix ozone with water, make sure using an efficient anti-back flow device, to prevent water back flow, The ozone tube should be placed in a higher position than the water flow, as well.)
รับประกันสินค้า 3 เดือน
รีวิว
ยังไม่มีบทวิจารณ์